Brake Pedal, With Manual Transmission

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench VAG 1410

Removing

To remove the brake pedal on vehicles with a manual transmission, the mounting bracket must be removed.

-- Remove the mounting bracket, refer to MOUNTING BRACKET, WITH MANUAL TRANSMISSION .

Remove the brake pedal on the removed mounting bracket.

-- Remove the bolt -3-.

Fig 1: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the retainer -1- on the left side and remove the pins -5- to the right.

Fig 2: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove brake pedal.

Install the Brake Pedal on the Removed Mounting Bracket

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

Fig 3: Overview Of Brake Pedal Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

-- Slide the right retainer onto the pins.

-- Slide the pins from right to left through the axle in the brake pedal.

-- Secure the pins with the left retainer -1-.

Fig 4: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pins must be secured with the retainers on both sides.

-- Install and tighten the bolt -3-.

Fig 5: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install the mounting bracket, refer to MOUNTING BRACKET, WITH MANUAL TRANSMISSION .