Ribbed belt, removing and installing: Installing
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Install in reverse order.
NOTE:
- Before installing the ribbed belt, make sure that all mechanical units (generator, air conditioning compressor, power steering pump) are securely attached.
- When installing the ribbed belt, make sure that the direction of rotation is correct and that the belt is installed correctly in the pulleys.
- On vehicles with an air conditioner, install the ribbed belt to the air conditioning compressor last.
- If the vibration damper/pulley is replaced, refer to Installing vibration damper/pulley .
- Install ribbed belt.
On completion of work, always:
- Start engine and check belt running.
Correctly installed belt