Installing vibration damper/pulley

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Vibration Damper/Pulley

GW00017320

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lock carrier in service position → Lock carrier, moving to service position .
Removing ribbed belt → Ribbed belt, removing and installing .

When installing vibration damper, only use genuine bolts

Vibration damper can only be installed in one position: Hole - arrow - in vibration damper must fit over projection on toothed belt sprocket.