Drive Plate: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification, refer to DRIVE PLATE OVERVIEW .

NOTE:

Replace bolts that are tightened to the specification.

There is a needled bearing in the drive plate. Check if the needle bearing is inserted before installing. Needle bearing, removing from and installing on drive plate, refer to NEEDLE BEARING ON DRIVE PLATE .

-- Be careful of the alignment bushings during installation.

-- Reposition the 10 - 201 to tighten the bolts.