Drive Plate Overview
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For assembly work, secure the engine on the engine and transmission holder VAS 6095. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
- Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the clutch module holes for cracks and signs of wear.
- Removing and installing, refer to DRIVE PLATE
- Bolt
- 60 Nm plus an additional 90° turn
- Replace
- Needle Bearing
- Installed position: Closed side faces the engine
- Removing and installing, refer to NEEDLE BEARING ON DRIVE PLATE
- Sensor Wheel
- For the Engine Speed (RPM) sensor -G28-
- Crankshaft
- Fitting Pin
- Crankshaft Shaft Seal, Transmission Side
- Removing and installing, refer to CRANKSHAFT SEAL, TRANSMISSION SIDE