Transmission Fluid Temperature Sensor 2 -G754-

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Oil Collecting and Extracting Device V.A.G 1782

The 7-speed S-Tronic transmission 0B5 has an additional transmission fluid temperature sensor 2 -- to monitor the transmission fluid temperature of the wheel set on certain engine versions.

Installed location: In place of the Manual Transmission Fluid (MTF) drain plug.

Procedure

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

Transmission Installed

-- Remove the rear noise insulation -2-. Refer to "Underbody Trim" in NOISE INSULATION .

CAUTION:

There is a risk of damaging the transmission.

Without any or with too little manual transmission fluid inside the transmission:

Do not start the engine and
Do not tow the vehicle

Transmission Removed

The transmission is secured to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .-

Transmission, Removed or Installed

-- Place the V.A.G 1782 under the transmission.

-- Disconnect the connector -2- from transmission fluid temperature sensor 2 --.

Fig 2: Identifying Transmission Fluid Temperature Sensor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Protect the connector -2- and the contacts on transmission fluid temperature sensor 2 -- from transmission fluid. Clean the connectors immediately if they come in contact with transmission fluid (MTF). Transmission fluid can cause contact problems in the connector contacts.

-- Remove transmission fluid temperature sensor 2 -- -1-.

-- Drain the transmission fluid (MTF).

Install in reverse order of removal. Note the following:

Tightening specification: Transmission fluid temperature sensor 2 -- to transmission, 45 Nm

-- Attach the wiring harness to the transmission -arrows-.

-- Fill with MTF, refer to General Information .

-- Clean the transmission and tunnel crossmember.