Starter, Removing And Installing, Vehicles With 3.0L TFSI And 3.2L FSI Engine: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seal -1- And Opening For Starter -2- -Arrow-

Courtesy of AUDI OF AMERICA, LLC

Tightening Specifications. Refer To OVERVIEW - STARTER .

Install In Reverse Order Of Removal. Note The Following:

-- If The Vehicle Has A Multitronic Transmission, Make Sure The Seal -1- Fits Correctly Inside The Starter Opening Before Installing The Starter.

The Sealing Piece Must Cover The Opening For The Starter -2- -arrow-.

-- Install The Engine Support And The Right Engine Mount. Refer To RIGHT ENGINE MOUNT, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] .

With Manual/Multitronic Transmission:

-- Install The Right Catalytic Converter. Refer To The Appropriate Service Information CATALYTIC CONVERTER, REMOVING AND INSTALLING - [FOR ENGINE CODES : CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] , CATALYTIC CONVERTER, REMOVING AND INSTALLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] , EMISSIONS CONTROL [FOR ENGINE(S) CALA] , CATALYTIC CONVERTER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] .

NOTE:

To Replace The Exhaust Manifold Gasket, The Exhaust Manifold Must Be Removed. Refer To EXHAUST PIPES/MUFFLERS, DISCONNECTING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] , FRONT MUFFLER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] , FRONT MUFFLER, REMOVING AND INSTALLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] and FRONT MUFFLER, REMOVING AND INSTALLING [FOR ENGINE(S) CALA] .

-- Install The Right Front Muffler. Refer To EXHAUST PIPES/MUFFLERS, DISCONNECTING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] , FRONT MUFFLER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] , FRONT MUFFLER, REMOVING AND INSTALLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] and FRONT MUFFLER, REMOVING AND INSTALLING [FOR ENGINE(S) CALA] .

-- Install The Plenum Chamber Bulkhead. Refer To PLENUM CHAMBER COVER, REMOVING AND INSTALLING / OVERVIEW - PLENUM CHAMBER BULKHEAD .

Continuation For All Vehicles:

-- Connect The Battery. Required Actions. Refer To CONNECTING .