Battery, Disconnecting And Connecting: Connecting
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening Specification: COUPE : Refer To OVERVIEW - BATTERY, COUPE ; SPORTBACK : Refer To OVERVIEW - BATTERY, SPORTBACK .
-- Disconnect The Connector -2- From The Battery Monitoring Control Module -J367- -Item 1-.
-- Connect The Ground Wire Terminal Clamp -3- By Hand To The Battery Negative Terminal - - - And Tighten The Nut.
-- Reconnect The Connector To The Battery Monitoring Control Module -J367-.
-- Install The Vehicle Tool Kit Cover. Refer To OVERVIEW - LUGGAGE COMPARTMENT FLOOR .
When The Battery Is Reconnected, The Following Steps Must Be Performed:
- Activate The One-Touch Up/One-Touch Down Power Window Regulators. Refer To The Owner's Manual.
- Check DTC Memories Of All Control Modules And Erase "Undervoltage" DTC If Necessary. Refer To Vehicle Diagnostic Tester.
NOTE:
After Reconnecting The Power Supply, The ESP Warning Lamp Can Only Go Out After The Vehicle Has Been Driven A Few Meters.