Starter, Removing And Installing, Vehicles With 1.8L And 2.0L TFSI Engine: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seal -1- And Opening For Starter -2- -Arrow-

Courtesy of AUDI OF AMERICA, LLC

Tightening Specifications. Refer To OVERVIEW - STARTER .

Install In Reverse Order Of Removal. Note The Following:

-- If The Vehicle Has A Multitronic Transmission And A 2.0L FSI Engine, Make Sure The Seal -1- Fits Correctly Inside The Starter Opening Before Installing The Starter.

The Sealing Piece Must Cover The Opening For The Starter -2- -arrow-.

Fig 2: Identifying Bolt & Spacer Sleeve

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There Is A Risk Of Damaging The Starter.

To Tighten The Bolt -2-, Insert The Spacer Sleeve -Arrow- Between The Starter And Transmission.

-- Install The Engine Support And The Right Engine Mount. Refer To RIGHT ENGINE MOUNT, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] .

-- Connect The Battery. Required Actions. Refer To CONNECTING .