Overview - Supercharger
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Lifting Eye
- Bolt
- 27 Nm
- Compressor
- With charge air coolers
- Supercharger, Removing and Installing, refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Charge Air Cooler Assembly Overview, refer to OVERVIEW - CHARGE AIR SYSTEM .
- Secure for work on the Engine And Transmission HolderVAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .
- Secure for leak test on the Engine And Transmission HolderVAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAKAGE TEST .
- Insulation Plate
- Bolt
- 5 Nm
- Rubber Grommet
- Quantity: 2
- Intermediate Flange
- Bolt
- Tightening specification, refer to Fig 2.
- Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Rings
- Replacing
- Connection
- Bolt
- Tightening specification and sequence, refer to Fig 3.
- Bracket
- For change-over valves
- Bolt
- 9 Nm
- Bolt
- Tightening specification and sequence, refer to Fig 3.
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing, refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bleed Screw
- 1.5 to 3.0 Nm
- For the left charge air cooler
- Bolt
- Tightening specification, refer to Fig 5.
- Intake Air Temperature Sensor -G42-
- Removing and installing, refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- O-Rings
- Replacing
- Nut
- 20 Nm
- O-Ring
- Replacing
- Threaded Pin
- 17 Nm
- Bolt
- 10 Nm
- Replacing
- Self-locking
- always clean the threaded holes with a thread tap before assembling
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing, refer to CHARGE AIR PRESSURE SENSOR -G31- / -G447-, REMOVING AND INSTALLING .
- Seals
- Replacing
- O-Ring
- Replacing
- Quantity 2
- Connection
- For the crankcase ventilation
- Installed position, refer to Fig 6
- O-Ring
- Replacing
- Quantity 2