Supercharger, Securing To Engine/Transmission Holder For Repair Work
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The openings on the bottom of the supercharger housing should make it possible to see and reach the charge air cooler.
Special tools and workshop equipment required
- Engine And Transmission HolderVAS6095
- Gearbox SupportT40206 with T40206/1 and Gearbox Support Supplement T40206/2
Procedure
- Supercharger removed, refer to SUPERCHARGER, REMOVING AND INSTALLING .
-- Install the Gearbox Support T40206 with T40206/1 in the Engine And Transmission HolderVAS6095.
-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1-.
-- Attach the Gearbox Support Supplement T40206/2 directly to the compressor housing at the front and on the right side using the bolt -2-.
Installation position of the Gearbox Support Supplement T40206/2:
- The seals -arrow 1- on the supports must face downward.
- It is possible to see and reach the charge air cooler through the openings -arrow 2- inside the supercharger housing.