Pendulum Support

Removing 

Fig 1: Removing Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulation -1-. Refer to "Underbody Trim Panels and Heat Shields" in Removal and Installation .

-- Remove the bolts -1, 2 and 3- and remove the pendulum support.

Fig 2: Identifying Pendulum Support & Bolts

Courtesy of AUDI OF AMERICA, LLC

Installing 

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to SUBFRAME MOUNT OVERVIEW .

-- Attach the pendulum support to the transmission, bolts -2 and 3- and then to the subframe -1-.

-- Install the noise insulation. Refer to "Underbody Trim Panels and Heat Shields" in Removal and Installation .