Transmission Mount And Transmission Support
Special tools and workshop equipment required
- Engine Support Bridge 10 - 222 A
- Bracket with Spindle and Hook 10 - 222 A /10
Removing
-- Remove the air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or to [For engine(s) BPY, CDMA] Removal and Installation .
-- Remove the bolts -arrows- and remove the air filter housing bracket.
-- Mount the 10 - 222 A on the upper edges of the bolted fender flange as illustrated.
-- Hook the spindle of the engine support bridge into the left engine lifting eye.
-- Slightly tension the engine with the spindle, do not lift.
Remove the Transmission Support:
It is not necessary to remove the transmission support in order to remove the transmission mount.
-- Remove the bolts -1 and 2-.
-- Lower the engine/transmission assembly slightly with the spindles.
-- Remove the transmission support -A-.
Transmission Mount, Removing:
-- Open the wiring guide bracket -arrows- and push the electric wires to the side.
-- Unclip wiring guide.
-- Remove the bolts -arrows-.
-- Remove the bolts -1- and the transmission mount -A-.
Installing
Install in reverse order, paying attention to the following:
- For the correct tightening specifications, refer to SUBFRAME MOUNT OVERVIEW .
-- Lift the transmission by the engine support bridge spindle until transmission support touches transmission mount support arm.
Risk of damaging the threads in the transmission support by inserting bolts crooked.
- Before installing bolts -arrows-, transmission support and transmission mount support arm must be absolutely parallel to each other. If necessary, raise rear of the transmission with trolley jack.
-- Remove subframe. Refer to [For engine(s) CETA, CCTA] Description and Operation or to [For engine(s) CDMA] Description and Operation or to [For engine(s) BPY] Description and Operation .
-- Install transmission mount support arm on transmission support.
-- Remove 10 - 222 A from engine.
-- Install the air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or to [For engine(s) BPY, CDMA] Removal and Installation .