Backrest Cover

Special tools and workshop equipment required 

• Pry lever 80 - 200
  Fig 1: Identifying Pry Lever 80-200

  Courtesy of AUDI OF AMERICA, LLC

Fig 2: Identifying Backrest Cover Overview

Courtesy of AUDI OF AMERICA, LLC

1. Right backrest cover
   • Removing and Installing, refer to Fig 3
2. Left backrest cover
   • Removing and Installing, refer to Fig 3
3. Retaining clip
4. Bolt
   • Tightening specification 2.5 Nm
   • Replace with locking compound
   • Locking compound
5. Seat belt guide outer part
   • Removing and Installing, refer to Fig 4
6. Seat belt guide inner part
   • With release lever
   • the version without the backrest release is shown in the illustration
   • To remove, remove backrest cover. Refer to BACKREST COVER AND UPHOLSTERY
   • Disassembling Figure
7. Backrest frame

Fig 3: Affixing Backrest Panel All Around Trim Using Adhesive Tape

Courtesy of AUDI OF AMERICA, LLC

-- Affix backrest panel all around trim -1- using adhesive tape -2-.

-- Using pry lever80-200, pry off upper backrest cover at inner side, starting from backrest panel.

-- Disengage clip at front corner of backrest panel extremely carefully.

Fig 4: Guiding Pry Lever 80 - 200 Between Backrest Cover And Outer Part Of Belt Guide

Courtesy of AUDI OF AMERICA, LLC

-- Carefully guide the pry lever80-200 between the backrest cover and belt guide outer part.

-- Carefully press to disengage outer part of belt guide from inner part of belt guide.