Accessory Assembly Bracket
Removing
-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .
-- Remove ribbed belt. Refer to RIBBED BELT .
-- Remove the generator. Refer to [For transmission(s) 02E] Removal and Installation .
-- Disconnect the Air Conditioning (A/C) compressor regulator valve -N280- -1- connector from the A/C compressor.
Refrigerant can cause serious personal injury.
- Do not open the air conditioning refrigerant circuit.
-- Remove A/C compressor bolts -arrows-.
Risk of damaging refrigerant lines and hoses.
- Do not stretch, kink or bend refrigerant lines and hoses.
-- Tie up the compressor with the refrigerant lines attached to the longitudinal member.
-- Remove the bolt -arrow- for the oil dipstick guide tube.
-- Remove the bolts -1 through 5- and pull off the accessory assembly bracket from the coolant pump housing.
Installing
- For the correct tightening specifications, refer to RIBBED BELT DRIVE OVERVIEW .
Installation is carried out in the reverse order while noting the following:
Replace bolts that are tightened to the specification.
Replace the O-rings and seals.
-- Coat the O-rings -4- with coolant additive. For the correct coolant.
-- Install the connection -2- into the coolant pump housing -3-.
-- Press the accessory assembly bracket -1- onto the connection, mount the bolts and tighten. Refer to Figure.
-- Install A/C compressor. Refer to Removal and Installation .
-- Install the generator. Refer to [For transmission(s) 02E] Removal and Installation .
-- Install the ribbed belt. Refer to RIBBED BELT .
-- Fill the coolant system. Refer to COOLANT, DRAINING AND FILLING => Filling: .