Part II
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to OVERVIEW - VALVETRAIN .
- Cylinder Head
- Only replace together with the cylinder head cover
- O-ring
- Lubricate with engine oil
- Check for damage
- No replacement part: included in the cam adjustment actuator delivery package
- Cam Adjustment Actuator
- Cam Adjustment Actuator 1 -F366-
- Cam Adjustment Actuator 2 -F367-
- Cam Adjustment Actuator 3 -F368-
- Cam Adjustment Actuator 4 -F369-
- Cam Adjustment Actuator 5 -F370-
- Cam Adjustment Actuator 6 -F371-
- Cam Adjustment Actuator 7 -F372-
- Cam Adjustment Actuator 8 -F373-
- Removing and installing. Refer to CAM ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .
- Bring into the installation position. Refer to Installing .
- Bolt
- 5 Nm
- Ball Pin
- 9 Nm
- For the engine cover
- O-ring
- Always replace after removing.
- Coat with engine oil
- Plugs
- O-ring
- Always replace after removing.
- Coat with engine oil
- Cam Position Sensor 3 -G300-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification -item 8- OVERVIEW - IGNITION SYSTEM .
- Oil Separator
- Removing and installing.
- Bolt
- Tightening Specifications and Sequence. .
- Seal
- Always replace after removing.
- Vacuum Pump
- Removing and installing. Refer to VACUUM PUMP, REMOVING AND INSTALLING
- Bolt
- Tightening specification. Refer to VACUUM PUMP, REMOVING AND INSTALLING .
- Seal
- Always replace if damaged
- O-ring
- Replace after removing.
- Coat with engine oil
- Cam Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification -item 13- OVERVIEW - IGNITION SYSTEM .
- Bolt
- 9 Nm
- Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-