Placing Dual Clutch In Transmission Housing
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
-- Place the dual clutch as shown in the transmission housing.
-- Tighten the bolts -1 to 12- for the clutch cover diagonally in steps. Tightening specification. Refer to OVERVIEW - FLYWHEEL AND DUAL CLUTCH . Refer to -item 6- Bolt.
-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- After installing the transmission fill the ATF and transmission fluid. Refer to ATF, DRAINING AND FILLING and TRANSMISSION FLUID, DRAINING AND FILLING
- After Changing The Dual Clutch The Clutch Must Be Adapted. Refer To Vehicle Diagnostic Tester.