Transmission Fluid Auxiliary Hydraulic Pump -V552-, Removing And Installing: Installing: Notes
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Contamination Damages The Mechatronic.
- A clean work environment is required for working on the Mechatronic.
-- Place the ATF pump on the ATF motor at the same time pay attention to the correct alignment of the anti-twist mechanism -arrows-.
-- Drive the ATF motor and ATF pump using the :T10492 in the valve body.
-- With the :T10492 install and tighten the bolts evenly all the way.
-- Remove the :T10492 .
Tightening Specification. Refer to OVERVIEW - VALVE BODY .
-- Install the Transmission Control Module -J217-. Refer to Transmission Control Module -J217-, REMOVING AND INSTALLING .
- After replacing the Transmission Fluid Auxiliary Hydraulic Pump -V552- the function "calibrating the fluid auxiliary hydraulic pump" must be performed. Refer to Vehicle Diagnostic Tester.