Solenoid Valves And Pressure Regulating Valves In Valve Body, Removing And Installing: Installing: Notes
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
-- Coat the valve surface with ATF and push in the valves all the way.
-- Hold the Solenoid Valve 5 -N92- in direction of -arrow-.
-- Using the :T40100 align the connection evenly as shown.
-- Connect the contact element evenly.
-- Install the bolts in direction of -arrows- and tighten to the tightening specification.
-- Tighten the bolts -arrows- to the Tightening Specification.
Tightening Specification: OVERVIEW - VALVE BODY .
-- Install the Transmission Control Module -J217-. Refer to Transmission Control Module -J217-, REMOVING AND INSTALLING .
-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- After replacing the Solenoid Valves -- the function "Calibrating valves" must be performed using the Vehicle Diagnostic Tester.