Electrical harness connectors, disconnecting
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Connector point cover
Removing
- Remove seat → Seat, removing and installing .
- Tip front seat - 2 - back.
- Remove coupling station cover - 1 - upward.
- Press in tab on connector for voltage supply - 5 - on tunnel side and disconnect connector for voltage supply.
- Press in tab on connector for heated seat - 4 - on tunnel side and disconnect connector for heated seat.
For vehicles with seatbelt fasten sensor:
- Press in tab on connector for seatbelt fasten sensor - 3 - on tunnel side and disconnect connector for seatbelt fasten sensor.
Installing
Installation is reverse of removal.
2 - Front seat
3 - Belt buckle sensor connector (black)
- Depending on version
4 - Seat heating connector (green)
5 - Current supply connector (red)
6 - Connector housing with terminal resistance for side airbag
- Depending on the version, this terminal resistance is securely connected to the wiring harness, or is designed as a separate connector housing with terminal resistance.
- Installation location → Connector housing with terminal resistance for side airbag