Release Cable
- Lid Latch
- Removing and Installing. Refer to Cable Coupling .
- To adjust the hood, slide up or down.
- Hood Cable
- Removing:
-- Disconnect the release cable at the coupling. Refer to Cable Coupling .
-- Disengage the release cable from the bracket -7-.
-- Pull the release cable through to the engine compartment.
- Installing: install in reverse order of removal
- Removing:
- Cable Coupling
-- Slide the coupling clamp sideways onto the bracket -8- on the lock carrier.
-- Disconnect the release cable here before removing the lock carrier and release lever.
- Hood Lock Rear Cable
- Release cable to the operating lever in the vehicle interior.
- Grommet
- Make sure it fits correctly when installing.
- Operating Lever
- Disengage the release cable. Refer to Hood Release Lever, Removing .
- Lid Lock Release Lever
- Operating lever cover, removing. Refer to Release Lever Cover, Removing .
- Lock Carrier
- Wire
- Pull the electrical wire and the lid lock cable through the lock carrier as shown.
- Clip
- Slide the clamp with the electrical wire onto the tab in the lock carrier.