LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S4 Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (General, Technical Data - Automatic Transmission 0B6 AWD (AVANT)) >> 00 General, Technical Data >> Specifications >> Transmission Fluid Capacities

Transmission Fluid Capacities

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

ATF area in the Transmission 

Capacities Automatic Transmission 0B6
Original filling by the manufacturer Approximately 10.4 liters
Change
  • No change
  • Permanent fill; only change after repairs such as when removing the ATF pan
Lubricant ATF for automatic transmission 0B6,
CAUTION:

There is a risk that the transmission could malfunction or fail.

  • Only use the ATF available as a replacement part with the automatic transmission 0B6.

ATF, CHECKING LEVEL AND CORRECTING

Front Final Drive 

Capacities Automatic Transmission 0B6
Initial filling 1.0 liters
Change
  • No change
  • Permanent fill; change only after repairs such as removing the front final drive cover
Lubricant Gear oil for automatic transmission 0B6

GEAR OIL LEVEL IN FRONT FINAL DRIVE, CHECKING AND FILLING

Transfer Case 

Capacities Automatic Transmission 0B6
Initial filling 1 liter
Change
  • No change
  • Permanent fill; change only after repairs such as removing the center differential housing
Lubricant Gear oil for automatic transmission 0B6

GEAR OIL LEVEL IN TRANSFER CASE, CHECKING AND FILLING