Right Flange Shaft Seal

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Oil Collecting and Extracting Device V.A.G 1782
Extractor Lever VW 681
Thrust Piece T40189

Procedure

NOTE:

Automatic transmission clean working conditions, refer to CLEAN WORKING CONDITIONS .

General repair instructions, refer to REPAIR INFORMATION .

-- Place the V.A.G 1782 under the transmission.

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Remove the right flange shaft seal.

Fig 1: Flange Shaft Oil Seal, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference of the new shaft seal with axle oil.

Installed position: The open side of the shaft seal faces the transmission.

-- Drive on in new shaft seal as far as stop. When doing this, do not bend the shaft seal or install it on an angle.

Fig 2: New Shaft Seal, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Axle oil, adding to transmission after repair. Refer to GEAR OIL IN FRONT FINAL DRIVE, FILLING AFTER REPAIR .