Gear Oil In Front Final Drive, Filling After Repair
WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Oil Collecting and Extracting Device V.A.G 1782
- Protective eyewear
Filling
- The front final drive cover was removed and all of the gear oil has drained through it.
- Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
- Gear oil temperature at approximately 20 °C (68 °F) (room temperature).
- Tightening specification, refer to FRONT FINAL DRIVE OVERVIEW .
NOTE:
General repair instructions, refer to REPAIR INFORMATION .
Automatic transmission clean working conditions, refer to CLEAN WORKING CONDITIONS .
-- Place the V.A.G 1782 under the transmission.
WARNING:
Danger of eye injury.
- Wear protective eyewear.
-- Remove the plug -arrow-.
-- Fill the front final drive with gear oil slowly over a period of at least 5 minutes until oil drips from the bottom of the inspection opening.
- For the correct transmission fluid.
NOTE:
A filling time of at least 5 minutes is required so that the internal oil level between the differential and oil fill space can equalize.
Replace the drain plug and gasket.
-- Tighten the new sealing plug.
NOTE:
It is not necessary to check the oil level again at this stage.