LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> Steering >> Steering Linkage >> STEERING (2 Of 2) >> 48 Steering >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

Component Fastener Size Nm
Belt Pulley to Power Steering Pump Bolt
- V6 TDI - 23
- V6 FSI and TFSI - 25
Bracket for Hydraulic Oil Cooler on Condenser - 9
Control Line to Steering Gear Bolt - 12
Control Line to Steering Gear Banjo Bolt - 40
Handle to Steering Column Bolt - 4.5
Heat Shield to Steering Gear Bolt - 10
Power Steering Line Bracket Bolt - 9
Power Steering Pressure/Return Line to Steering Gear Mounting Bolt - 9
Power Steering Pressure/Return Line to Steering Gear Union Nut - 32
Power Steering Pressure/Return Line Union Nut - 32
Power Steering Pump to Bracket Bolt
- V6 TDI - 23
- V6 FSI and TFSI - 25
Power Steering Pump Mounting Bolt, V8 FSI
- Transmission/engine/power steering pump bolt - 85
- Other bolts - 22
Pressure Line to Power Steering Pump
- Banjo Bolt - 35
- Bolt, V6 TDI Engine, Generation I with SCR and on a V6 TDI Engine, Generation II - 9
Protective Boot Nut (1) - 4
Reservoir to Bracket Bolt - 8
Servotronic Solenoid Valve to Steering Gear Bolt (3) - 3
Steering Column to Lateral Control Arm Bolt/Nut (2) - 20
Steering Column to Steering Gear Bolt (1) - 35 + 90° turn
Steering Gear to Subframe Nut (1) - 90 + 90° turn
Steering Wheel to Steering Column Bolt (1) - 50
Tie Rod to Steering Gear - 100
Tie Rod End to Tie Rod Nut - 70
Tie Rod End to Wheel Bearing Housing Nut (1) - 90
(1) Always replace after removal.
(2) Follow tightening sequence. Refer to Figure.
(3) Always follow tightening sequence. Refer to Servotronic Solenoid Valve -N119- .
scientia non olet · About LEMON Manuals