SERVOTRONIC Solenoid Valve -N119-

Special tools and workshop equipment required 

• Torque Wrench V.A.G 1783
• Steering gear grease

Removing 

Request values with vehicle diagnostic tester, refer to item  17.

-- With vehicles with air suspension, place vehicle on hoist. Refer to the appropriate service information .

-- Only remove front noise insulation -1-.

-- Always clean steering gear -6- in servotronic solenoid valve -- -3- area.

-- Make sure that no dirt enters steering gear -6-.

-- Separate connector -8-.

-- Make sure no dirt enters the connector -8-.

-- Remove bolts -1- and -2-.

-- Remove servotronic solenoid valve -- -3- from steering gear -6-.

-- Remove screen -7- from steering gear -6-, clean steering gear if necessary.

Installing 

Install in reverse order of removal. Note the following:

-- Insert a new screen -7-.

-- Lightly coat gasket -4 and 5- with steering gear grease and insert. Place servotronic solenoid valve -- -3- in steering gear -6- as far as stop. Do not tilt servotronic solenoid valve -- when doing so.

-- Tighten bolts -1 and 2- as follows:

1. Tighten bolt -1- to 0.5 Nm.
2. Tighten bolt -2- to 1.5 Nm.
3. Tighten bolt -1- to 3.0 Nm.
4. Tighten bolt -2- to 3.0 Nm.

-- On vehicles with air suspension, position vehicle on wheels. Refer to the appropriate service information .