Engine Support, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Tighten the subframe. Refer to SUBFRAME, SECURING .

-- Install the Secondary Air Injection Pump Motor -V10-. Refer to Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING .

-- Attach the universal joint to the steering gear. Refer to POWER STEERING GEAR, REMOVING AND INSTALLING .

-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .

-- Install the front wheel housing liners and noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Be sure to follow the procedure for connecting the battery and afterwards. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- On vehicles with air suspension, deactivate vehicle lift mode. Refer to VEHICLE LIFT MODE .