Suction Jet Pumps: Installing

• Tightening specification, refer to FUEL DELIVERY UNIT AND FUEL LEVEL SENSOR -G- OVERVIEW .

Install in reverse order of removal. Note the following:

-- Insert suction jet pumps in guide and press them down until they engage audibly.

-- Slide delivery lines with suction jet pipe through left opening on fuel tank to right fuel tank chamber.

-- Insert fuel level sensor 2 in guide and press it down until it engages audibly.

-- Connect electrical connector -arrow- on the underside of left locking flange.

-- Install the new locking flange seal dry.

-- Bring the left locking flange into the installation position.

• The tab -2- on left locking flange faces toward the arrow marking and must lie between tabs -1 and 3- on the fuel tank.

-- Push the suction jet pipe -2- onto the suction jet pump until it engages audibly.

-- Attach the delivery lines -1 and 4- to the fuel delivery unit making sure they click into the place.

-- Attach fuel line -arrow- until it engages audibly.

-- Connect electrical connectors -1 and 2- on underside of right locking flange.

-- Install the new locking flange seal dry.

-- Bring the right locking flange into the installation position.

• Tab -2- on right locking flange faces toward arrow marking and must lie between tabs -1 and 2- on fuel tank.

-- Install locking flange cover.

-- Install the frame into the floor covering. Refer to FRONT FLOOR COVERING, REMOVING AND INSTALLING .

-- Remove seat frame and seat cushion in 2nd seating row. Refer to SECOND ROW, 2 PASSENGER OVERVIEW .

-- Be sure to follow the procedure for connecting the battery and afterwards. Refer to BATTERY .