Evaporative Emission (EVAP) Canister: Installing
WARNING: This page is about a different variant/trim than selected.
- Tightening specification, refer to EVAP SYSTEM OVERVIEW .
Install in reverse order of removal. Note the following:
-- Clip GND line onto EVAP canister -arrow-.
Fig 1: Identifying Vacuum Line -2-, Vent Lines -3 To 4-, And EVAP Canister Bolts Tightening Sequence: -6, 5, 7-
-- Install the EVAP canister and tighten the bolts in the following sequence: -6, 5 and 7-.
-- Install vacuum line -2- on fuel system diagnostic pump.
-- Install the vent lines -3 and 4-.
-- Install right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINERS, REMOVING AND INSTALLING .
-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to VEHICLE LIFT MODE .