Radiator, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to OVERVIEW - RADIATOR
NOTE:
If there are small impressions on the fins. Refer to COOLER AND CONDENSER ASSEMBLY .
-- Tighten ATF lines.
-- Tighten the power steering hydraulic lines. Refer to POWER STEERING PUMP, HYDRAULIC PIPES AND RESERVOIR OVERVIEW .
-- Install the refrigerant lines. Refer to COMPRESSOR REFRIGERANT LINES, DISCONNECTING AND CONNECTING .
-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .
-- Fill the refrigerant system. Refer to COOLANT, DRAINING AND FILLING [ .
-- Connect the coolant hose to the coupling. Refer to Figure.
NOTE:
If radiator was replaced, coolant must be changed.
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .