Overview - Radiator
WARNING: This page is about a different variant/trim than selected.
- Hydraulic Fluid Cooler
- For power steering
- ATF Cooler
- For the automatic transmission
- Clamp
- Make sure it is secure
- Air Guide
- Air Guide
- Radiator
- Removing and installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- Change the coolant after replacing
- Grommet
- Bolt
- 5.5 Nm
- Sealing Strip
- O-Ring
- Replace
- Coolant Hose
- Illustration does not correspond to version in vehicle.
- Connect to the radiator. Refer to Fig 2
- Coolant Hose
- Coolant Hose
- Connect to the radiator. Refer to Fig 2
- O-Ring
- Replace
- Bolt
- 8 Nm
- Retainer
- For the radiator
- Rubber Buffer
- Washer
- Bolt
- 8 Nm
- Clamp
- Make sure it is secure
- Clamp
- Make sure it is secure
- Condenser
- For air conditioning system
-- Remove the old O-ring -2- in the coolant hose -3-.
-- Coat the new O-ring with coolant and install it in the coolant hose.
-- Press the coolant hose onto the connection -1- until it engages audibly.
-- Press the coolant hose on again and pull to make sure the connection is engaged correctly.