Ribbed Belt, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specification. Refer to OVERVIEW - SUPERCHARGER RIBBED BELT DRIVE .
-- Place the ribbed belt over the pulley as illustrated.
- Generator
- Idler roller
- Coolant pump
- Power steering pump
- A/C compressor
- Ribbed belt tensioning damper
- Vibration damper
NOTE:
When installing the ribbed belt, make sure it is seated correctly on the pulleys.
-- Start the engine and check the belt routing.
-- Install the compressor ribbed belt. Refer to SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING .