Overview - Supercharger Ribbed Belt Drive
WARNING: This page is about a different variant/trim than selected.
- Ribbed Belt
- For the supercharger
- Check for wear
- Removing and installing. SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING
- When installing, make sure it is seated correctly on the ribbed belt pulleys
- Bolt
- 40 Nm
- Washer
- Cover
- Supercharger
- Overview. Refer to OVERVIEW - SUPERCHARGER
- Idler Roller
- For the ribbed belt
- Vibration Damper
- With ribbed belt pulley
- Installation is only possible in one position because of the offset holes
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING
- Bolt
- Tightening specification: 20 Nm + 90° turn.
- Tensioner
- For the ribbed belt
- Removing and installing. Refer to SUPERCHARGER RIBBED BELT TENSIONER, REMOVING AND INSTALLING
- Bolt
- 40 Nm