Overview - Supercharger
WARNING: This page is about a different variant/trim than selected.
- Engine Lifting Eye
- Bolt
- Tightening specification: 27 Nm
- Supercharger
- With charge air coolers
- Supercharger, removing and installing. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Charge air cooler assembly overview. Refer to OVERVIEW - CHARGE AIR COOLER .
- Secure for work on the Engine And Transmission Holder VAS 6095. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER .
- Secure for leak test on the Engine And Transmission Holder VAS 6095. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAKAGE TEST .
- Insulation Plate
- Bolt
- Tightening specification: 5 Nm
- Rubber Grommet
- Quantity: 2
- Intermediate Flange
- Bolt
- Tightening specification. Refer to Special Tools .
- Throttle Valve Control Module -J338-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Connection
- Bolt
- Tightening specification and sequence. Refer to Special Tools .
- Bracket
- for change-over valves
- Bolt
- Tightening specification: 9 Nm
- Bolt
- Tightening specification and sequence. Refer to Special Tools .
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing. Refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bleeder Screw
- For the left charge air cooler
- 1.5 to 3.0 Nm.
- Bolt
- Tightening specification. Refer to Special Tools
- Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-
- Removing and installing. Refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Nut
- Tightening specification: 20 Nm
- O-Ring
- Replace
- Threaded Pin
- Tightening specification: 17 Nm
- Bolt
- Tightening specification: 10 Nm
- Replace
- Self-locking
- Always clean the threaded holes with a thread tap before assembling
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31- / Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING
- Seals
- Replace
- O-Ring
- Quantity 2
- Replace
- Connecting Piece
- For the crankcase ventilation
- Installed position. Refer to Fig 2
- O-Ring
- Quantity 2
- Replace