Charge Air Pressure Sensor -G31- / Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to OVERVIEW - SUPERCHARGER .
NOTE:
Replace the self-locking screws and the O-ring.
Clean the threaded holes for the charge air pressure sensor inside the supercharger housing with a thread tap before assembling.
Only remove the plugs or caps after installing the lines.
-- Install the fuel supply line. Refer to Fuel Supply .