Timing Mechanism Drive Chain, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

-- Position the timing mechanism drive chain according to the markings made on the drive chain sprockets during removal.

-- Install the guide rail and tighten the bolts -1-.

Fig 1: Identifying Bolts And Chain Tensioner

Courtesy of AUDI OF AMERICA, LLC

-- Install the chain tensioner and tighten the bolts -2-.

-- Press the drive chain tensioner guide rail in direction of -arrow- and pull Locking PinT40071 out of the chain tensioner.

-- Install the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .

-- Position the camshaft timing chain on the camshafts. Refer to Installing .

-- Install the timing chain cover lower section. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .