Overview - Fuel Delivery Unit/Suction JETION Pump/Fuel Level Sensor, Vehicles With 3.0L (V6)/4.2L (V8) Engines From 06/2010
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Retaining Ring
- Welded to the fuel tank
- Fuel Level Sensor -G-
- Clipped into the retaining ring -1-
- For checking the resistance values, refer to Fuel Level Sensor -G-, CHECKING .
- Removing and installing, refer to Fuel Level Sensor -G-, REMOVING AND INSTALLING .
- Fuel Delivery Unit
- With Transfer Fuel Pump -G6-
- Check the electric fuel pump using Guided Fault Finding , refer to Vehicle Diagnostic Tester
- Inserted in the retaining ring -1- and turned 15° clockwise to engage (bayonet connection)
- Removing and installing, refer to Transfer Fuel Pump - G6-, REMOVING AND INSTALLING, VEHICLES WITH 3.0L (V6)/4.2L (V8) ENGINES FROM 06/2010 .
- Fill the fuel tank with at least 5 liters (5.28 qts) of fuel after installing
- Right Locking Flange
- Installed position, refer to Installing
- Seal
- Replacing
- Install dry
- Locking Ring
- Tighten to 110 Nm
- Remove and install with the Wrench - Fuel Sending UnitT10202
- Fuel Supply Line
- To the metering pump for the auxiliary heater
- Do not kink
- Clipped in on fuel tank
- Connector couplings, disconnecting, refer to CONNECTOR COUPLINGS, SEPARATING .
- Fuel Return Line
- From engine
- Do not kink
- Clipped in on fuel tank
- Connector couplings, disconnecting, refer to CONNECTOR COUPLINGS, SEPARATING .
- Fuel Supply Line
- To fuel filter
- Do not kink
- Clipped in on fuel tank
- Connector couplings, disconnecting, refer to CONNECTOR COUPLINGS, SEPARATING .
- Locking Ring
- Tighten to 110 Nm
- Remove and install with the Wrench - Fuel Sending UnitT10202
- Seal
- Replacing
- Install dry
- Left Locking Flange
- Installed position, refer to Installing
- Suction Jet Pump
- Clipped onto the retaining ring -14-
- Removing and installing, refer to SUCTION JET PUMP, REMOVING AND INSTALLING, VEHICLES WITH 3.0L (V6)/4.2L (V8) ENGINES FROM 06/2010 .
- Different versions.
- Fill the fuel tank with at least five liters of fuel after installing
- Retaining Ring
- Welded to the fuel tank
- Fuel Level Sensor 2 -G169-
- Clipped onto the retaining ring -14-
- For checking the resistance values, refer to Fuel Level Sensor 2 -G169-, CHECKING .
- Removing and installing, refer to Fuel Level Sensor 2 -G169-, REMOVING AND INSTALLING .
- Bolt/Nut
- 3.5 Nm
- Quantity: 2
- Fuel Pump Control Module -J538-
- Installed location: in the front of the fuel tank above the exhaust system and the driveshaft.
- Checking in Guided Functions , refer to Vehicle Diagnostic Tester
- Removing and installing, refer to Fuel Pump Control Module -J538-, REMOVING AND INSTALLING .