Fuel Level Sensor 2 -G169-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification, refer to OVERVIEW - FUEL DELIVERY UNIT/FUEL LEVEL SENSOR .

NOTE:

Replace the seal.

-- Before installing, check the routing of the wires on the Fuel Level Sensor 2 -G169-.

Fig 1: Fuel Level Sensor 2 Clip Locations

Courtesy of AUDI OF AMERICA, LLC

-- The wire must be clipped into the tabs -arrows- as illustrated.

-- Insert the Fuel Level Sensor 2 -G169- into the guide until it clicks into place.

-- Install the new seal for the left locking flange dry.

-- Bring the locking flange into the installation position. Refer to Installing .

Fig 2: Locking Flange Cover

Courtesy of AUDI OF AMERICA, LLC

The tab -2- on left locking flange faces toward the arrow marking and must lie between tabs -1 and 3- on fuel tank.

-- Install the left locking flange cover, refer to Figure.

-- Insert the frame into the floor covering, refer to the Parts Catalog and Interior Trim .

-- Install the left single seat and the left 2/3 seat bench seat cushion in the second row of seats, refer to Seat Frames .