Accelerator Pedal Module With Throttle Position Sensors, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification, refer to ACCELERATOR PEDAL MODULE OVERVIEW .

Install in reverse order of removal. Note the following:

-- Install the driver side lower instrument panel cover, refer to INSTRUMENT PANEL COVERS ON DRIVER SIDE OVERVIEW .

-- Perform after the first kick-down adaptation in "Guided Functions", refer to Vehicle Diagnostic Tester.

NOTE:

An adaptation may need to be performed after replacing, depending on the engine/transmission combination.

If there is a menu option in "Guided Functions", perform an adaptation, refer to Vehicle Diagnostic Tester.