Rear Belt Height Adjuster (2ND Row), Removing And Installing: Installing
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replacement seat belt height adjusters are always in the bottom-most locking position (assembly position).
If removed seat belt height adjusters are reinstalled, these should be placed in the bottom-most position (assembly position).
-- Engage seat belt height adjuster -4- in the C-pillar.
-- Install screw -5- and tighten it to the specification.
-- Install the safety belt relay -2- and tighten screw -3- to the tightening specification.
-- Install the C-pillar trim on the body. Refer to C-PILLAR TRIM OVERVIEW .
Tightening specification. Refer to OUTER THREE-POINT SEAT BELT (2ND ROW) OVERVIEW .