Ignition Overview
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition Coils with Power Output Stages
- Cylinder 1 ignition coil 1 with power output stage -N70-
- Cylinder 2 ignition coil 2 with power output stage -N127-
- Cylinder 3 ignition coil 3 with power output stage -N291-
- Cylinder 4 ignition coil 4 with power output stage -N292-
- Cylinder 5 ignition coil 5 with power output stage -N323-
- Cylinder 6 ignition coil 6 with power output stage -N324-
- Removing and installing, refer to IGNITION COILS .
- 4-Pin Harness Connector
- For ignition coils with power output stage
- Bracket
- For Knock Sensor (KS) 1 -G61- connector
- Bolt
- 10 Nm
- 3-Pin Harness Connector
- Black
- With gold-plated terminals
- Knock Sensor (KS) 1 -G61-
- Removing and installing, refer to Knock Sensor 1 -G61- / Knock Sensor 2 -G66- .
- Bolt
- 20 Nm
- Follow exact tightening specification for proper knock sensor function
- Camshaft Adjuster
- Exhaust side
- With sensor wheel for Camshaft Position (CMP) sensor 2 -G163-
- Camshaft Timing Chain Upper Cover
- 3-Pin Harness Connector
- Black
- With gold-plated terminals
- Mark before removing
- Bolt
- 10 Nm
- Camshaft Position (CMP) Sensor 2 -G163-
- For exhaust camshaft
- Seal
- Replace
- Camshaft Position (CMP) Sensor -G40-
- For intake camshaft
- Knock Sensor (KS) 2 -G66-
- Removing and installing, refer to Knock Sensor 1 -G61- / Knock Sensor 2 -G66- .
- 2-Pin Harness Connector
- Black
- With gold-plated terminals
- Camshaft Adjuster
- Intake side
- With sensor wheel for CMP)sensor --
- Spark Plug
- Removing and installing, refer to Additional Maintenance Items
- Control Housing
- For camshaft adjustment