Timing Chain Upper Cover Seal, Removing And Installing
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Bearing Installer - Rear Wheel Bearing Kit3253
- Fitting Sleeve3378
Removal
Fig 1: Identifying Seal Installer 3378 In Cover Piece -1- And Seal Installer 3253/6 From Assembly Tool 3253
Proceed as follows:
-- Remove timing chain upper cover upper section, refer to TIMING CHAIN GUARD UPPER SECTION, REMOVING AND INSTALLING .
-- Drive sealing ring out of timing chain upper cover with a drift.
Installation
-- Fit sealing ring with Fitting Sleeve3378 in timing chain upper cover -1-.
-- Pull sealing ring in flush with Bearing Installer - Rear Wheel Bearing Kit - Press Piece3253/6.
-- Install the timing chain cover upper section, refer to TIMING CHAIN GUARD UPPER SECTION, REMOVING AND INSTALLING .