ATF Pan, Removing And Installing: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

General Repair Instructions. Refer to REPAIR INFORMATION .

Automatic Transmission Clean Working Conditions, refer to TRANSMISSION, CLEAN WORKING CONDITIONS .

-- Remove bolts and remove rear noise insulation -2-.

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Place the used oil collection and extraction deviceV.A.G 1782 under the transmission.

Fig 2: Identifying Bolt Loosening Sequence -13 to 1-

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Wear protective eyewear.

-- Remove the drain plug -arrow A-.

-- Drain the ATF.

-- Loosen oil pan bolts in -13 to 1- sequence and remove oil pan.