Selector Lever Cable, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Shift Unit & Seat Sleeve

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

Tightening specifications: SELECTOR LEVER CABLE, ASSEMBLY OVERVIEW

-- Secure selector lever cable to cable that was guided in during removal.

-- Guide the selector lever cable with boot -2- into the selector mechanism shift unit -1-.

CAUTION:

Selector shaft lever must not be bend when pressing selector lever cable on, counterhold if necessary.

-- Carefully remove the selector lever cable -2- from the selector shaft lever.

Fig 2: Identifying Locking Washer & Selector Lever Cable

Courtesy of AUDI OF AMERICA, LLC

-- Secure selector lever cable sleeve to bracket using a new clip -1-.

-- Carefully insert boot -arrow- all around in selector mechanism shift unit.

Fig 3: Pushing Boot Forward And Out From Shift Unit

Courtesy of AUDI OF AMERICA, LLC

-- Install shift mechanism function unit SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .

-- Adjust selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING

Tightening Specification

Component		Nm
Heat shield to transmission		9