EGR Motor -V338-, REMOVING AND INSTALLING: Installation

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification. Refer to EXHAUST GAS RECIRCULATION OVERVIEW .

NOTE:

Replace the o-ring.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Check the coolant level, refer to COOLANT, DRAINING AND FILLING .