Exhaust Gas RECIRCULATION Overview
WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Part 1
- EGR Pipe
- Washer
- Replace
- Clip
- Tightening specification: 9 Nm
- Installation position: as illustrated.
- Coolant Hose
- EGR Coolant Thermostat with Connection
- Clamp
- O-Ring
- Replace
- O-Ring
- Replace
- Bolt
- Tightening specification: 9 Nm
- EGR Motor -V338-
- With EGR Potentiometer -G212-.
- Removing and Installing. Refer to EGR Motor -V338-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification: 9 Nm
- EGR Change-Over Vacuum Diaphragm
- Bolt
- Tightening specification: 9 Nm
- Coolant Hoses
- EGR Temperature Sensor -G98-
- Tightening specification: 45 Nm
- Removing and Installing. Refer to EGR Temperature Sensor -G98-, REMOVING AND INSTALLING .
- Coat with hot bolt paste; Hot bolt paste.
- 35 Nm Aluminum Exhaust Gas Recirculation Radiator
- 45 Nm Steel Exhaust Gas Recirculation Radiator
- Bolt
- Tightening specification: 9 Nm
- Crankcase Ventilation Pipe
- Bolt
- Tightening specification: 5 Nm +90° turn
- EGR Pipe
- Seal
- Replace
- Bolt
- Tightening specification: 9 Nm
- EGR Cooler
- With by-pass valve for the exhaust gas recirculation cooler.
- Removing and Installing. Refer to EGR COOLER, REMOVING AND INSTALLING .
- O-Ring
- Replace
- Coolant Hose
Part 2
- Auxiliary EGR Cooler
- Removing and Installing. Refer to EGR AUXILIARY COOLER, REMOVING AND INSTALLING .
- Seal
- Replace
- Bolt
- Tightening specification: 9 Nm
- EGR Pipe
- EGR Pipe
- With catalytic converter.
- Removing and Installing. Refer to EGR PIPE AND CATALYTIC CONVERTER, REMOVING AND INSTALLING .
- Bolt
- Tightening specification: 9 Nm
- Seal
- Replace
- Bolt
- Tightening specification: 9 Nm
- Vacuum Hose
- From the EGR Cooler Switch Over Valve 2 -N381-.
- Rear Coolant Pipe
- Removing and Installing. Refer to REAR COOLANT PIPE, REMOVING AND INSTALLING .
- O-Ring
- Replace
- Bolt
- Tightening specification: 9 Nm (Rear coolant pipe)
- Bolt
- Tightening specification: 9 Nm (Rear coolant pipe)
- Coolant Pipe
- O-Ring
- Replace
- Bolt
- Tightening specification: 9 Nm