EGR Cooler, Removing And Installing: Installation

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to EXHAUST GAS RECIRCULATION OVERVIEW .

NOTE:

Replace the seals and the o-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Connect the coolant hose to the coupling, refer to Fig 1.

Fig 1: Connecting Coolant Hose Coupling

Courtesy of AUDI OF AMERICA, LLC

-- Install the intake flap motors. Refer to OVERVIEW - INTAKE MANIFOLD .

-- Install the coolant line, refer to COOLANT PIPES OVERVIEW .

-- Install the turbocharger heat shield and oil supply line, refer to TURBOCHARGER OVERVIEW .

-- Install the oil filter housing. Refer to OIL FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the right upper coolant pipe. Refer to UPPER RIGHT COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the upper left coolant pipe. Refer to LEFT UPPER COOLANT PIPE, THROUGH 05.10, REMOVING AND INSTALLING .

-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING .