Engine Mount: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to SUBFRAME OVERVIEW .

Installation is in reverse order of removal, note the following:

-- Install the heat shield for the steering gear boot. Refer to STEERING GEAR OVERVIEW .

-- Install the power steering supply pipe. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING .

-- Check the power steering hydraulic fluid level. Refer to POWER STEERING, CHECKING HYDRAULIC OIL LEVEL .

-- Install air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to VEHICLE LIFT MODE .