Oil Cooler: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to GENERATOR RIBBED BELT DRIVE OVERVIEW (see Figure).

Installation is in reverse order of removal, note the following:

NOTE:

Replace O-rings.

Secure all hose connections with hose clamps appropriate for the model.

-- Install generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .