Selector Lever Handle Locking Button, Checking

WARNING: This page is about a different car, the 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

The ignition is switched on.

Locking button on selector lever handle must be pressed for the following shifts. If it is not pressed, the selector lever cannot be shifted into the specified position.

Move the selector lever from "P" into "R" and press the brake pedal at the same time.
"D" into "S"
"N" into "R" ; stationary, press the brake pedal after waiting longer
"R" into "P"

If the specified values are not obtained:

-- Make sure the selector lever handle is installed correctly. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .

-- Adjusting. Refer to SELECTOR LEVER CABLE, ADJUSTING .